23 in stock
| 1 - 4 | $132.92 |
| 5 + | $124.62 |
| Item Code | Price | Stock |
| SA1645R-5M | $ 144.14 | 5 |
| SA1645R-10M | $ 279.53 | 4 |
| SA1645R-20M | $ 558.71 | 5 |
$144.14 – $558.71 Excl. GST
DOWNLOADS
Check out the latest product specifications and guides.
Product Specification
Installation Guide
IES File
Power Calculator
Easy to estimate your power supply needs.
Our power calculator helps you determine the power supply needed for your LED light projects.
*Simply answer the questions below, and you'll receive a quick recommendation.
Use one power supplier per single piece of neon flex over 20M.
Enter the required number of the LEDs or Metre
METREWhere will the power supplies be installed?
e.g) Strip or Neon Flex : 8 Metres
558 in stock
| Box -100 Connectors | $0.32 / each |
Dimension
| Weight | N/A |
|---|---|
| Dimensions | 8 × 1300 × 12 mm |
| POWER |
9.6W |
| VOLTAGE |
DC 24V |
| CURRENT(A) |
0.4A |
| LUMINOUS FLUX |
70.83lm |
| EFFICIENCY |
2.95lm/W |
| COLOUR |
DEEP PINK(ROSE) |
| CRI |
80 |
| VIEWING ANGLE |
180° |
| IP RATING |
IP 67 |
| DIMMABLE |
DIMMABLE, Dimmable with HLG Power Only |
| CUTTABLE |
50mm |
| LENGTH |
3M, 5M, 10M, 20M |
| WARRANTY |
5 YEAR |
 |
Special Note ROLL LENGTHS_Any claim for short supply will only be considered while |
| Problems | Reasons | Solutions |
|---|---|---|
| No illumination | No electricity supply | Ensure LED driver is working |
| Automatic power protection from the open or short circuit in output of the power supply | Fix the short circuit problem | |
| Wrong connection of power supply | ||
| Partial illumination | Using a switching mode power supply | Make it as follows: Don’t use switching mode power supplies |
| Wire connection mistake | Check connections | |
| Brightness of LED is inconsistent for inconsistent | Power overloaded | Replace with a power supply that delivers 125% of current required to power the product |
| Voltage drop due to exceeding max-in-series limit | Adhere to the max-in-series limit specified on the product page | |
| LED Flickering | Connection point fault | Fix bad connection point |
| Use a proper LED driver | Replace a new power supply |
Products Features
Important Note
|
Installation Precautions 1. All installation and connection must be conducted by qualified electrician. 2. A 12V DC class 2 power supply unit must be used with this LED NEON FLEX. 3. Disconnect the mains power before installing or servicing to avoid electrocution. 4. For a wet location installation you must seal all possible water entry points including covers with clear silicone. |
No account yet?
Create an Account
