Call us for free now: 07 3219 6711 service@sa-led.com

SA NSF2-4M Slim LED Neon Flex 9.6W 12V 6500K (5 Metre / Unit)

Availability: 88 in stock


$106.46 $48.75 excl. g.s.t


Key Features & Benefits:

Item Code : SA 66741
High Quality 2835 LED
IP67 rate
Side bending and small size for easy modeling
12V DC low voltage, safe and reliable
3 End cap(with hole) x 3 End cap (without hole)
Cutting mark by every 25mm
5years Warranty




Quantity:

Share it:
Power Calculator

METRE Indoor Outdoor

 

 

 

Special Note

ROLL LENGTHS_Any claim for short supply will only be considered while
the NEON FLEX is in one length, to prove any manufacturing discrepancy.

*Note that once you cut the roll it will void any claim for short supply of the product.

Troubleshooting Common Faults

Problems Reasons Solutions
No illumination No electricity supply Ensure LED driver is working
Automatic power protection from the open or short circuit in output of the power supply Fix the short circuit problem
Wrong connection of power supply
Partial illumination Using a switching mode power supply Make it as follows: Don’t use switching mode power supplies
Wire connection mistake Check connections
Brightness of LED is inconsistent for inconsistent Power overloaded Replace with a power supply that delivers 125% of current required to power the product
Voltage drop due to exceeding max-in-series limit Adhere to the max-in-series limit specified on the product page
LED Flickering Connection point fault Fix bad connection point
Use a proper LED driver Replace a new power supply

*Note that should be cut and reconnected with end connectors for installation to avoid defects due to moisture penetration. The steps below indicate are possible way of sealing the end:

Installation steps

Cut the neon flex Weld the wire to the PCB board First put silicone glue inside
of the plug, and quick connector
then push into the neon flex
Wipe off the excess glue and
wait for the glue to solidify.

 

[ Important Notice ] How to solder to LED neon flex

 

   Cutting Mark By Every 25 mm

Products Features

Note. Soldering Required

Important Note

Dimensions(mm)

Dimensions 8 × 5000 × 12 mm
MODEL

SA NSF2-4M SLIM LED NEON FLEX_PW

POWER

9.6W/M

CURRENT(A)

0.8A

LENGTH

[ SA66741 ] 5M ($9.75/M)

VOLTAGE

DC 12V

LUMINOUS FLUX

344lm

EFFICIENCY

28.7lm

CCT(K)

6500K

COLOUR

PURE WHITE

CRI

80

VIEWING ANGLE

115°

IP RATING

IP67

DIMMABLE

DIMMABLE

CUTTABLE

25mm

AVAILABLE LENGTH

5M

LED Qty/m

120

WARRANTY

5 YEARS

Reviews


Be the first to review “SA NSF2-4M Slim LED Neon Flex 9.6W 12V 6500K (5 Metre / Unit)”

*

Navigation

MY CART

Close

No products in the cart.

No products in the cart.

WISHLIST

Close

No products were added to the wishlist