Sale
29 in stock
Title | Range | Price |
---|---|---|
SA 66686-5 / Customer | 1 - 4 | $76.79 $76.79 |
SA 66686-5 / Customer | 5 + | $67.19 $67.19 |
Need to buy accessories as well ? (click)
For expert tips and tutorials to take your lighting projects to the next level.
$186.42 $76.79 Excl. GST
29 in stock
Title | Range | Price |
---|---|---|
SA 66686-5 / Customer | 1 - 4 | $76.79 $76.79 |
SA 66686-5 / Customer | 5 + | $67.19 $67.19 |
DOWNLOADS
Power Calculator
Easy to estimate your power supply needs.
Our power calculator helps you determine the power supply needed for your LED light projects.
*Simply answer the questions below, and you'll receive a quick recommendation.
Enter the required number of the LEDs or Metre
METREWhere will the power supplies be installed?
e.g) Strip or Neon Flex : 8 Metres
Dimension
Dimensions | 8 × 5000 × 12 mm |
---|---|
POWER |
11.52W |
VOLTAGE |
DC 12V |
CURRENT(A) |
0.96A |
LUMINOUS FLUX |
138lm |
EFFICIENCY |
11.97lm/W |
COLOUR |
GREEN |
CRI |
80 |
VIEWING ANGLE |
139° |
IP RATING |
IP 67 |
DIMMABLE |
DIMMABLE |
CUTTABLE |
10.4mm |
LENGTH |
5M |
WARRANTY |
5 YEAR |
Special Note ROLL LENGTHS_Any claim for short supply will only be considered while |
Problems | Reasons | Solutions |
---|---|---|
No illumination | No electricity supply | Ensure LED driver is working |
Automatic power protection from the open or short circuit in output of the power supply | Fix the short circuit problem | |
Wrong connection of power supply | ||
Partial illumination | Using a switching mode power supply | Make it as follows: Don’t use switching mode power supplies |
Wire connection mistake | Check connections | |
Brightness of LED is inconsistent for inconsistent | Power overloaded | Replace with a power supply that delivers 125% of current required to power the product |
Voltage drop due to exceeding max-in-series limit | Adhere to the max-in-series limit specified on the product page | |
LED Flickering | Connection point fault | Fix bad connection point |
Use a proper LED driver | Replace a new power supply |
*Note that should be cut and reconnected with end connectors for installation to avoid defects due to moisture penetration. The steps below indicate are possible ways of sealing the end:
Installation steps
Cut the neon flex | Weld the wire to the PCB board | First put silicone glue inside of the plug, and quick connector then push into the neon flex |
Wipe off the excess glue and wait for the glue to solidify. |
[ Important Notice ] How to solder to LED neon flex
Cutting Mark By Every 10.4 mm |
Note. Soldering Required
Important Note
Installation Precautions 1. All installation and connection must be conducted by qualified electrician. 2. A 12V DC class 2 power supply unit must be used with this LED NEON FLEX. 3. Disconnect the mains power before installing or servicing to avoid electrocution. 4. For a wet location installation you must seal all possible water entry points including covers with clear silicone. |
Dimensions(mm)
No account yet?
Create an Account