Sale
For expert tips and tutorials to take your lighting projects to the next level.
Item Code | Price | Stock |
SA 1AB-5M | $ 89.07 | 7 |
SA 1AB-10M | $ 177.76 | 4 |
$89.07 – $177.76 Excl. GST
DOWNLOADS
Power Calculator
Easy to estimate your power supply needs.
Our power calculator helps you determine the power supply needed for your LED light projects.
*Simply answer the questions below, and you'll receive a quick recommendation.
Enter the required number of the LEDs or Metre
METREWhere will the power supplies be installed?
e.g) Strip or Neon Flex : 8 Metres
Dimension
Weight | N/A |
---|---|
Dimensions | 5000 × 11 × 12 mm |
POWER |
12W |
VOLTAGE |
DC 24V |
CURRENT(A) |
0.5A |
LUMINOUS FLUX |
353lm |
EFFICIENCY |
30lm/W |
COLOUR |
RED |
CRI |
80 |
IP RATING |
IP 67 |
DIMMABLE |
DIMMABLE |
CUTTABLE |
50mm |
LENGTH |
5M, 10M |
WARRANTY |
5 YEAR |
Special Note ROLL LENGTHS_Any claim for short supply will only be considered while |
Problems | Reasons | Solutions |
---|---|---|
No illumination | No electricity supply | Ensure LED driver is working |
Automatic power protection from the open or short circuit in output of the power supply | Fix the short circuit problem | |
Wrong connection of power supply | ||
Partial illumination | Using a switching mode power supply | Make it as follows: Don’t use switching mode power supplies |
Wire connection mistake | Check connections | |
Brightness of LED is inconsistent for inconsistent | Power overloaded | Replace with a power supply that delivers 125% of current required to power the product |
Voltage drop due to exceeding max-in-series limit | Adhere to the max-in-series limit specified on the product page | |
LED Flickering | Connection point fault | Fix bad connection point |
Use a proper LED driver | Replace a new power supply |
*Note that should be cut and reconnected with end connectors for installation to avoid defects due to moisture penetration. The steps velow indicate are possible way of sealing the end:
Installation steps
Cut the neon flex | Weld the wire to the PCB board | First put silicone glue inside of the plug, and quick connector then push into the neon flex |
Wipe off the excess glue and wait for the glue to solidify. |
Cutting Mark By Every 50 mm |
Important Note
Dimensions(mm)
No account yet?
Create an Account